Arnd
Autogasforum-Anfänger  Beiträge: 2 Registriert: 7. 9. 2004 Status: Offline
|
am 7. 9. 2004 um 16:45 |
Hallo,
vielleicht kann mir jemand sagen,wie an einer alten IMCO Venturianlage das Gemisch eingestellt wird.
Am Verdampfer sind zwei aussen-6-Kant-
Schrauben.Ich gehe davon aus,das eine davon fürs Standgasgemisch ist.Welche?
Rausdrehen=Fetter?Motor ist ein alter
Vergaser V8.Vielleicht hat jemand auch
Unterlagen hierfür in Kopie.Natürlich gegen
Endgeld.
Beste Grüsse Arnd.
|
| |
JosvanDartel
Autogasforum-Junior  Beiträge: 230 Registriert: 12. 8. 2004 Status: Offline
|
am 8. 9. 2004 um 12:39 |
It is not possible to do that on the gasconverter. To adjust the mixture you have do that at the mixer on top of the carburretor. If you have a CA300 mixer, there is an elbow at the top to which the gashose is connected. Under the 13 mm bolt you can find the screw to adjust the idle mixture. At the side of the elbow you can find a sort of bolt with two flat sides. This is for adjusting the mixture for full speed. If you look you can turn to lean or rich. That depents on wether the engine is performing on the road.
Good luck
|
| |
Arnd
Autogasforum-Anfänger Beiträge: 2 Registriert: 7. 9. 2004 Status: Offline
|
am 11. 9. 2004 um 12:40 |
Hi Josvan,
thanx for your support.
You`re rigth,I`ve found both of the screws
at the mixer.I have not got the time to try
a tune up yet,but I will soon.
It runs pretty good on LPG,exept for the
idleing with an Automatic gear in.It feels
that there are some missfireing,sometimes,
on very low RPM.Fireing itself is O.K..
Maybe I can solve the Problem now.
Thanx again,Arnd.
|
| |
Autogas / LPG News & Infos
Autogas - Forum
